Recalling Default Setups; Performing A Secure Erase - Agilent Technologies InfiniiVision 4000 X-Series User Manual

18
Save/Email/Recall (Setups, Screens, Data)
See Also •

Recalling Default Setups

1 Press the [Save/Recall] key.
2 In the Save/Recall Menu, press Default/Erase.
3 In the Default Menu, press one of these softkeys:

Performing a Secure Erase

1 Press the [Save/Recall] key.
2 In the Save/Recall Menu, press Default/Erase.
3 In the Default menu, press Secure Erase.
320
"To edit arbitrary waveforms"
Default Setup— recalls the oscilloscope's default setup. This is the same
•
as pressing the front panel [Default Setup] key. See
Oscilloscope Setup"
Some user settings are not changed when recalling the default setup.
Factory Default— recalls the oscilloscope's factory default settings.
•
You must confirm the recall because there are no user settings that
are left unchanged.
This performs a secure erase of all non- volatile memory in compliance
with National Industrial Security Program Operation Manual (NISPOM)
Chapter 8 requirements.
You must confirm the secure erase, and the oscilloscope will reboot
when finished.
on page 289
on page 33.
Agilent InfiniiVision 4000 X-Series Oscilloscopes User's Guide
"Recall the Default