Table of Contents
Advertisement
Cal ler Id enti fi cation (ICLID )
Calling Number (SMDR)
As with feature implementation, the intent is that the system operate normally in the
absence of ICLID information or the failure of the ICLID equipment. If the information is
present at the time that an SMDR record is generated for a call, it will alter the content
and format of the SMDR output record.
If the calling number is available, the number will be output in the SMDR record in the
same location as the dialed number is located in the outgoing calls.
Unanswered calls will be recorded on the SMDR as a system option to allow the
identification of callers for statistical and call-back purposes. These calls will be identified
with an (NA) indicator in Station Number space of the SMDR the SMDR record.
When Incoming Caller ID is provided by the servicing telephone company, the caller data
may be retrieved at the CO line interface and delivered to the
ancillary device connected to the ICLID/PC Programming RS-232 port. This external
(optional) device must be configured in the
from the unit to the
For instance -- if the telephone company CO line with caller ID feature enabled is
connected to the
position 4; CO line 1 of the
line circuit that is to be used with telephone company caller ID must be programmed
with an associated ICLID device port number.
The default value 0 indicates that no caller ID will be received on this CO line.
Default
The
DHS-L
DHS-L
line position to be used with the caller ID line.
DHS-L
on CO line position 1 and connected to the ICLID device -
DHS-L
CO calls must be in progress for a minimum of 10 sec for an SMDR record to be generated
for that call.
CO Lines (1-96) are set for (0)—not associated with an ICLID Port number.
Wait_ICLID time in Call Handling must also be enabled to allow the
collectthe callerIDdatabefore ringingany system telephones. In addition,ICLID requires
Telephone Company service and the following additional hardware.
Default = 4 sec.
Chapt er 3 - Key Station Features, Opera tion, and Programming
DHS-L
to associate the line circuit number
must be programmed for ICLID Port 04. Each
DHS-L
KSU via an external
DHS-L
DHS-L
systems to
3-67
CO
Advertisement
Table of Contents
