Misb Cut Sheet - STARPLUS DHS-L Technical Manual

2-34
Chapter 2 - Description and Installation
1. To connect the trunks to the KSU, refer to the cross-connect wiring diagram in
2-19
connector that mates with the connector located on each trunk.
2. Install the cross-connect block to the right of the KSU allowing sufficient room to
access both sides of the block. There should be sufficient room between the bottom
of the card cage and the bottom of the KSU to route the cables.
3. Route cable up through the center of the cross-connect block, dress and secure the
cable at several points, and then punch down the leads using a standard color code.
DTMF Receiver Card Installation
The DTMF Receiver Card is a daughter card that snaps into the MISB, and connects to CN3
as shown in
which shows the wiring arrangement for the 24-pin champ amphenol-type
Port
MUSIC 1
801
MUSIC 2
802
PAGE 1
820
PAGE 2
821
Bell 1
810
Bell 2
811
not
used
not
used
Figure 2-19: MISB Cut Sheet
Figure 2-18 .
PIN # Color
13 WH/BL
1 BL/WH
14 WH/OR
2 OR/WH
15 WH/GN
3 GN/WH
16 WH/BN
4 BN/WH
17 WH/SL
5 SL/WH
18 RD/BL
6 BL/RD
19 RD/OR
7 OR/RD
20 RD/GN
8 GN/RD
21 RD/BN
9 BN/RD
22 RD/SL
10 SL/RD
23 BK/BL
11 BL/BK
24 BK/OR
12 OR/BK
DH S-L Instal lation
Figure