Table of Contents
Advertisement
Hold
Hold
Flash
Description
CO line calls and ICM calls may be placed on Hold.
Operation
While connected to a CO Line:
1. Press Hook Flash.
2. After a 2 second delay, dial tone is heard, and the party is placed on hold.
3. Hang up.
While connected to an intercom call:
1. Press Hook Flash.
2. Dial tone is heard, and the party is placed on hold.
3. Hang up.
Conditions
When an intercom/CO line call is placed on Hold and the holding party hangs up,
after the Hold Reminder time is elapsed, the system will ring the hold activating
station with internal or external ring signal. If Hold Reminder is disabled, 30 seconds
after the call is placed on hold, the system will give the holding party recall ring
(internal ring for held ICM call and external ring for held CO Line call). Refer to
3, Key Station Features, Operation, and Programming,
If Call Abandon is set and properly functioning, calls placed on hold will be released if
the outside party disconnects.
To answer Hold Recall at an SLT, lift the handset (refer to
Features, Operation, and Programming,
This feature may need to be adjusted on some telephones for proper operation.
Hot Line (Ring Down)
Description
This feature allows you to use the associated single line telephone (SLT) port for
automatic signaling to a predetermined destination. You can set up the Hot Line feature
to call another station or speed dial bin number.
Operation
1. Lift the handset.
2. Dial [#] + [9] + [✳].
Chapter 4 - SLT Features and Operation
and
"Reminder
Chapter 3, Key Station
and
"Transfer").
4-11
Chapter
Time".
Advertisement
Table of Contents
