Table of Contents
Advertisement
3-98
Chapter 3 - Key Station Features, Operation, and Programming
Hot Dial Pad
Description
When the Hot Dial Pad feature is enabled, the telephone keypad can be operated while
the telephone receiver is on-hook. When this feature is not enabled, the telephone
keypad can only be operated when the telephone receiver is off-hook.
Operation
To allow or deny (toggle) operation of the Hot Dial Pad:
Press [FEAT] + [#] + [6].
Hot Line (Ring Down)
Description
This feature allows you to use the associated enhanced, executive or single line
telephone (SLT) port for automatic signaling to a predetermined destination. When the
feature is enabled, the destination is signaled whenever that telephone goes off-hook.
You may hook-flash at the telephone where the feature is enabled so that you can
request intercom dial tone to perform other functions and change or disable the feature
when no delay time is programmed. You can set up the Hot Line feature to call another
Telephone, Hunt/Voice Mail Group, Paging Zone, CO line or CO line Group.
Programming
E
NHANCE D
1. Press [FEAT ] + [9] + [
2. Enter desired destination.
3. Dial the delay time (0-9) seconds.
(0= immediate, 1-9 = delay in seconds)
E
XE CU TIVE
1. Press [FEAT ] + [9] + [
2. Press [chg].
3. Enter desired destination.
4. Press [save]. The display shows:
T
--
EL EPHONE S
]. The display shows:
✳
T
--
ELE PHONES
]. The display shows:
✳
H OT LIN E TO :
i mm ed i at e
NU LL
c h g
d ela y
Hot Dial Pad
Advertisement
Table of Contents
