Table of Contents
Advertisement
Day/Ni ght Servic e
Conditions
New conference parties may only be added when the conference controller is a
member of the conference.
If an outside line hangs up, the line will be released.
Day/Night Service
Description
The system can be programmed for Night Service operation which affects incoming CO
line ringing and receive assignments. The Attendant of a Tenant Group may manually
switch the system service from Day to Night mode, or vice-versa using the Night Service
code. During Night Service mode, station and DISA Class Of Service (COS) outside dialing
privileges are changed in accordance with the Toll Restriction Night COS programming.
Operation
An Attendant when in idle mode, can activate Night Service from an attendant telephone
as follows:
1. Press [FEAT ] + [#] + [3] to program a DSS console button.
2. Press the soft button you wish to program for night service.
3. Press [chg].
4. Press [FEAT ]. The display shows:
5. Press [FEAT ] + [6] + [3].
6. Then press [save].
Conditions
Each time the Night Service code is entered, the system mode of operation changes
to the opposite mode.
When the system is in the Night Service mode, all Executive Key Telephones will
display night.
For Attendant Only -- Feature must be programmed on an feature key.
Dial Pulse to DTMF Conversion
Description
When a CO line is set to pulse (rotary) dialing, the digits following [
tone mode. Pulse-to-tone change-over can be programmed into any Speed Dial bin.
Chapt er 3 - Key Station Features, Opera tion, and Programming
SEL ECT FU N CTION
d i r f eat
3-83
] will be sent in DTMF
✳
Advertisement
Table of Contents
