Table of Contents
Advertisement
3-76
Chapter 3 - Key Station Features, Operation, and Programming
Default
The
DHS-L
Receive Assignment
Description
Receive Assignment allows flexibility of CO line incoming signaling. Stations in the
system may be programmed to follow CO line ringing condition of any of the CO lines.
This is not a ring assignment; rather a means of restricting certain stations from accessing
CO lines that are ringing. When set to Y the station CO line button (if programmed on the
telephone) will flash incoming ring flash while calls come into the system on that CO line.
Default
All
DHS-L
700-795.
Automatic Selection
Description
This feature allows you to access a specific outside line or intercom (ICM) automatically
when you lift the handset or press [SPKR].
A line will not be accessed automatically when your telephone is receiving an incoming
call (outside or intercom) or a line is recalling at your telephone. However, you may
override this incoming call priority operation by pre-selecting an outgoing line before
lifting the handset.
Operation
E
NHANCE D
1. Press [FEAT ].
2. Dial [9] + [5] + [0 or 1] + (Route number) + [9].
3. Dial the following codes to select the item you want the telephone to access
automatically: [0] - intercom, [1] - specific CO line number or route number from
Route Table.
4. Dial desired CO number (700-795).
E
XE CU TIVE
1. Press [FEAT ].
2. Dial [9] + [5]. The display shows:
CO Line Group Assignment is Group 1, the available Group range is from 1-24.
stations have access to incoming ringing CO Lines (Y), and the CO range is from
T
--
EL EPHONE S
T
--
ELE PHONES
SEL ECT
IC M
lin e
:
ICM
r o ut e
C O Li ne
Advertisement
Table of Contents
