Table of Contents
Advertisement
Cal ler Id enti fi cation (ICLID )
Programming
When Incoming Caller ID is provided by the servicing telephone company, the caller data
may be retrieved at the CO line interface and delivered to the
Caller ID device connected to the ICLID/PC Programming RS232 port. This external
(optional) device must be configured in the
from the unit to the
line circuit that is to be used with telephone company caller ID must be programmed
with an associated ICLID device port number. The default value 0 indicates that no caller
ID will be received on this CO line. For caller ID to function effectively, the baud rate must
be set to 2400.
K
S
U
Perform the following steps to program the Caller ID data collection module for the
DHS-L
system. From any executive station:
1. Press [FEAT ] + [#] + [0]. The display shows:
2. Press [1] + [save].
3. Dial default password (0000).
4. Press [next]. The display shows:
DHS-L
line position to be used with the caller ID line. Each
Male DB-9
1
2
3
4
5
6
7
8
9
Figure 3-8: Caller ID Connection
ICLID requires Telephone Company service and an ICLID Cable.
T1 requires ANI to be active.
TE NA N T
R S23 2 1 : R MP
Chapt er 3 - Key Station Features, Opera tion, and Programming
DHS-L
to associate the line circuit number
Connection
Male DB-9
1
2
3
4
5
6
7
8
9
DHS-L
KSU via an external
DHS-L
Caller ID
Box
3-63
CO
Advertisement
Table of Contents
