Chapter 3 Configuring A Dell Powerconnect W Group In Airwave; Basic Monitoring Configuration - Dell PowerConnect W-Airwave Manual

It is prudent to establish one or more Dell PowerConnect W Groups within AirWave. During the discovery
process you will move new discovered controllers into this group.
This chapter contains the following topics:
"Basic Monitoring Configuration" on page 9

"Advanced Configuration" on page 10


Basic Monitoring Configuration

1. Navigate to Groups > List.
2. Select Add.
3. Enter a Name that represents the Dell PowerConnect W-Series device infrastructure from a security,
geographical, or departmental perspective and select Add.
4. You will be redirected to the Groups > Basic page for the Group you just created. On this page you will need
to tweak a few Dell-specific settings.
5. Find the SNMP Polling Periods section of the page, as illustrated in
6. Change Override Polling Period for Other Services to Yes.
7. Ensure User Data Polling Period is set to 10 minutes. Do not configure this interval lower than 5 minutes.
NOTE: Enabling the SNMP Rate Limiting for Monitored Devices option in the previous chapter adds a small delay between each
SNMP Get request, thus the actual polling interval is 12 minutes for 10 minute polling interval.
8. Change Device-to-Device Link Polling Period to 30 minutes.
9. Change Rogue AP and Device Location Data Polling Period to 30 minutes.
Figure 6
SNMP Polling Periods section of Groups > Basic
10. Locate the Dell PowerConnect W section of this page, as illustrated in
Dell PowerConnect W-AirWave 7.5 | Best Practices Guide
Chapter 3
Configuring a Dell PowerConnect W
Group in AirWave
Figure 6.
Figure 7.
Configuring a Dell PowerConnect W Group in AirWave | 9