Configuring Wlse Initially In Airwave; Adding An Acs Server For Wlse; Enabling Rogue Alerts For Cisco Wlse; Configuring Wlse To Communicate With Aps - Dell PowerConnect W-Airwave User Manual

Table 34 Cisco SWAN Architecture Components (Continued)
SWAN Component
WLSE (Wireless LAN
Solution Engine)
ACS (Access Control
Server)
APs

Configuring WLSE Initially in AirWave

Use the following general procedures to configure and deploy a WLSE device in AirWave:

Adding an ACS Server for WLSE



Enabling Rogue Alerts for Cisco WLSE



Configuring WLSE to Communicate with APs


Discovering Devices

Managing Devices

Inventory Reporting

Defining Access

Grouping

WDS Participation

Primary or Secondary WDS

Adding an ACS Server for WLSE
1. Go to the Devices > Discover > AAA Server page.
2. Select New from the drop-down list.
3. Enter the Server Name, Server Port (default 2002), Username, Password, and Secret.
4. Select Save.
Enabling Rogue Alerts for Cisco WLSE
1. Go to the Faults > Network Wide Settings > Rogue AP Detection page.
2. Select the Enable.
3. Select Apply.
Additional information about rogue device detection is available in
on page 62.
Configuring WLSE to Communicate with APs
1. Go to the Device Setup > Discover page.
2. Configure
3. Configure HTTP Information.
4. Configure Telnet/SSH Credentials.
5. Configure HTTP ports for IOS access points.
6. Configure WLCCP credentials.
7. Configure AAA information.
Dell PowerConnect W-AirWave 7.4 | User Guide
Requirements
 IP Address
Login

IP Address

 Login
 APs within WDS Group
.
SNMP Information
"Configuring Cisco WLSE Rogue Scanning"
Configuring AMP | 59