Config Ipif - D-Link DGS-3120-24PC Manual

®
xStack DGS-3120 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
enable - Specify that the proxy ARP option will be enabled.
disable - Specify that the proxy ARP option will be disabled.
local - (Optional) This setting controls whether the system provides the proxy reply for the ARP
packets destined for IP address located in the same interface as the received interface. When
proxy ARP is enabled for an interface, the system will do the proxy reply for the ARP packets
destined for IP address located in a different interface. For ARP packets destined for IP
address located in the same interface, the system will check this setting to determine whether
to reply.
enable - Specify that the local option will be enabled.
disable - Specify that the local option will be disabled.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To create an IP interface:
DGS-3120-24TC:admin#create ipif Inter2 192.168.16.1/24 default state enable
secondary
Command: create ipif Inter2 192.168.16.1/24 default state enable secondary
Success.
DGS-3120-24TC:admin#

12-14 config ipif

Description
This command is used to configure the IP interface.
Format
config ipif <ipif_name 12> [{ipaddress <network_address> | vlan <vlan_name 32> | state
[enable | disable]} | proxy_arp [enable | disable] {local [enable | disable]} | bootp | dhcp |
ipv6 [ipv6address <ipv6networkaddr> | state [enable | disable]] | ipv4 state [enable | disable]
| dhcpv6_client [enable | disable] | dhcp_option12 [hostname <hostname 63> |
clear_hostname | state [enable|disable]]]
Parameters
ipif - Specify the name of the IP interface.
<ipif_name 12> - Enter the IP interface name used here. This name can be up to 12
characters long.
ipaddress - (Optional) Configures a network on an ipif. The address should specify a host
address and length of network mask. Since an ipif can have only one IPv4 address, the new
configured address will overwrite the original one.
<network_address> - Enter the network address used here.
vlan - (Optional) Specify the name of the VLAN here.
<vlan_name 32> - Enter the VLAN name used here. This name can be up to 32 characters
long.
state - (Optional) Enable or disable the state of the interface.
enable - Enable the state of the interface.
147