D-Link DGS-3120-24PC Manual page 256

®
xStack DGS-3120 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
DGS-3120-24TC:admin# show dhcp_relay ipif System
Command: show dhcp_relay ipif System
DHCP/BOOTP Relay Status
DHCP/BOOTP Hops Count Limit
DHCP/BOOTP Relay Time Threshold : 0
DHCP Vendor Class Identifier Option 60 State: Disabled
DHCP Client Identifier Option 61 State: Disabled
DHCP Relay Agent Information Option 82 State
DHCP Relay Agent Information Option 82 Check
DHCP Relay Agent Information Option 82 Policy : Replace
DHCP Relay Agent Information Option 82 Remote ID : 00-80-C2-00-32-E0
Interface Server 1
------------ --------------- --------------- --------------- ---------------
Server VLAN ID List
--------------- -----------------------------------------------------------
10.43.21.12 1-10
DGS-3120-24TC:admin#
24-10 config dhcp_relay option_60
Description
This command is used to decide whether DHCP relay will process the DHCP option 60 or not.
When option_60 is enabled, if the packet does not have option 60, then the relay servers cannot
be determined based on option 60. The relay servers will be determined based on either option 61
or per IPIF configured servers.
If the relay servers are determined based on option 60 or option 61, then per IPIF configured
servers will be ignored.
If the relay servers are not determined either by option 60 or option 61, then per IPIF configured
servers will be used to determine the relay servers.
Format
config dhcp_relay option_60 state [enable | disable]
Parameters
state - Specify that the DHCP relay function should use the option 60 rule to relay the DHCP
packets.
enable - Specify that the option 60 rule will be enabled.
disable - Specify that the option 60 rule will be disabled.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
: Disabled
: 4
: Disabled
: Disabled
Server 2 Server 3
252
Server 4