Chapter 78 Stacking Command List - D-Link DGS-3120-24PC Manual

®
xStack DGS-3120 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide

Chapter 78 Stacking Command List

config box_priority current_box_id <value 1-6> priority <value 1-63>
config box_id current_box_id <value 1-6> new_box_id [auto | <value 1-6>]
show stack_information
show stack_device
config stacking_mode [disable | enable]
show stacking_mode
config stacking force_master_role state [enable | disable]
config stacking trap state [enable | disable]
config stacking log state [enable | disable]
78-1 config box_priority
Description
This command is used to configure the priority of switch, which will determines which box becomes
master. Lower number means higher priority. New priority will take effect after user reboot.
Format
config box_priority current_box_id <value 1-6> priority <value 1-63>
Parameters
current_box_id - Specify the Switch being configured. The range is 1-m, where the m.is
determined by device type. For example, to the DGS3120 Series, it is 6.
<value 1-6> - Enter the current box ID here. This value must be between 1 and 6.
priority - Specify the priority assigned to the box, with lower number meaning higher priority. The
range is 1-63.
<value 1-63> - Enter the higher priority value here. This value must be between 1 and 63.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To configure box priority:
DGS-3120-24TC:admin#config box_priority current_box_id 1 priority 1
Command: config box_priority current_box_id 1 priority 1
Success.
DGS-3120-24TC:admin#
713