Config Radius - D-Link DGS-3120-24PC Manual

®
xStack DGS-3120 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
Format
config radius delete <server_index 1-3>
Parameters
<server_index 1-3> - Specify to delete a RADIUS server.Enter the RADIUS server index.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To delete a radius server:
DGS-3120-24TC:admin# config radius delete 1
Command: config radius delete 1
Success.
DGS-3120-24TC:admin#
4-23

config radius

Description
This command is used to configure a RADIUS server.
Format
config radius <server_index 1-3> {ipaddress [<server_ip> | <ipv6addr>] | [key <password
32> | encryption_key <password 56>] | auth_port [<udp_port_number 1-65535 > | default] |
acct_port [<udp_port_number 1-65535> | default] | timeout [<sec 1-255> | default] |
retransmit [<int 1-20> | default]}
Parameters
<server_index 1-3> - Enter the RADIUS server index here. This value must be between 1 and 3.
ipaddress - (Optional) The IP address of the RADIUS server.
<server_ip> - Enter the RADIUS server IP address here.
<ipv6addr> - Enter the RADIUS server IPv6 address used here. (EI Mode Only)
key - (Optional) The key pre-negotiated between switch and RADIUS server. It is used to encrypt
user's authentication data before being transmitted over internet. The maximum length of the
key is 32.
<password 32> - Enter the key here. The key can be up to 32 characters long.
encryption_key - The key pre-negotiated between the Switch and the RADIUS server. It is used
to encrypt user's authentication data before being transmitted over the Internet. The maximum
length of the key is 32.
<password 56> - The encrypted key string. The maximum length of the plain text key is 56
bytes. The encryption algorithm is based on DES.
auth_port - (Optional) Specify the UDP port number which is used to transmit RADIUS
authentication data between the Switch and the RADIUS server. The range is 1 to 65535. The
default value is 1812.
55