Show Traffic Control - D-Link DGS-3120-24PC Manual

®
xStack DGS-3120 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
Parameters
none - No trap state is specified for storm control.
storm_occurred - Occurred mode is enabled and cleared mode is disabled.
storm_cleared - Occurred mode is disabled and cleared mode is enabled.
both - Both occurred and cleared modes are enabled.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To enable both the occurred mode and cleared mode traffic control traps:
DGS-3120-24TC:admin# config traffic trap both
Command: config traffic trap both
Success.
DGS-3120-24TC:admin#
86-3

show traffic control

Description
This command is used to display the current traffic control settings.
Format
show traffic control {<portlist>}
Parameters
<portlist> - (Optional) Used to specify the range of ports to be shown.
If no parameter is specified, the system will display the packet storm control configuration for all
ports.
Restrictions
None.
Example
To display the traffic control parameters for ports 1 to 10:
758