D-Link DGS-3120-24PC Manual page 761

®
xStack DGS-3120 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
the Switch that will trigger the storm traffic control measure. The threshold is expressed as
PPS (packets per second) and must be an unsigned integer.
<value 0-1488100> - Enter the upper threshold value here. This value must be between 0 and
1488100.
broadcast_threshold - Specify the number of broadcast packets per second received by the
Switch that will trigger the storm traffic control measure.
<value 0-1488100> - Enter the value between 0-148810.
multicast_threshold - Specify the number of multicast packets per second received by the
Switch that will trigger the storm traffic control measure.
<value 0-1488100> - Enter the value between 0-148810.
unicast_threshold - Specify the number of unicast packets per second received by the Switch
that will trigger the storm traffic control measure.
<value 0-1488100> - Enter the value between 0-148810.
countdown - (Optional) Timer for shutdown mode. If a port enters the shutdown Rx state and
this timer runs out, port will be shutdown forever. The parameter is not applicable if "drop"
(mode) is specified for the "action" parameter.
<min 0> - 0 disables the forever state, meaning that the port will not enter the shutdown
forever state.
<min 3-30> - Enter the countdown timer value here. This value must be between 3 and 30.
disable – Specify that the countdown timer will be disabled.
time_interval - (Optional) The sampling interval of received packet counts. The possible value
will be m-n seconds. The parameter is not applicable if "drop" (mode) is specified for the
"action" parameter.
<sec 5-600> - Enter the time interval value here. This value must be between 5 and 600.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To configure the parameters so that the traffic control status is enabled on ports 1-12:
DGS-3120-24TC:admin# config traffic control 1:1-1:12 broadcast enable action
shutdown threshold 1 countdown 5 time_interval 10
Command: config traffic control 1:1-1:12 broadcast enable action shutdown
threshold 1 countdown 5 time_interval 10
Success.
DGS-3120-24TC:admin#
86-2 config traffic trap
Description
This command is used to configure trap modes.
Occurred Mode: This trap is sent when a packet storm is detected by the packet storm
mechanism.
Cleared Mode: This trap is sent when the packet storm is cleared by the packet storm mechanism.
Format
config traffic trap [none | storm_occurred | storm_cleared | both]
757