Quick Steps For Configuring Port Mirroring - Alcatel-Lucent OmniSwitch 6850-48 Network Configuration Manual

Port Mirroring Overview

Quick Steps for Configuring Port Mirroring

1
Create a port mirroring session. Be sure to specify the port mirroring session ID, source (mirrored) and
destination (mirroring) slot/ports, and unblocked VLAN ID (optional—protects the mirroring session
from changes in Spanning Tree if the mirroring port will monitor mirrored traffic on an RMON probe
belonging to a different VLAN). For example:
-> port mirroring 6 source 2/3-9 destination 2/10 unblocked 7
Note. Optional. To verify the port mirroring configuration, enter
the port mirroring session ID number. The display is similar to the one shown below:
-> show port mirroring status 6
Session Mirror
Destination
----------+----------+--------------+----------+----------+---------
6. 2/10
----------+----------+--------------+----------+----------+---------
Mirror
Source
----------+----------+--------------+----------+----------+---------
6. 2/3
6. 2/4
6. 2/5
6. 2/6
6. 2/7
6. 2/8
6. 2/9
For more information about this command, see
"Port Mirroring and Monitoring Commands" chapter in the OmniSwitch CLI Reference Guide.
page 45-4
Mirror Unblocked
Direction Vlan
- NONE
bidirectional -
bidirectional -
bidirectional -
bidirectional -
bidirectional -
bidirectional -
bidirectional -
"Displaying Port Mirroring Status" on page 45-21
OmniSwitch AOS Release 6 Network Configuration Guide
Diagnosing Switch Problems
show port mirroring status
Config Oper
Status Status
Enable On
Enable On
Enable On
Enable On
Enable On
Enable On
Enable On
Enable On
followed by
or the
September 2009