Online - Yamaha DME64N Owner's Manual

Chapter 2 DME Designer Overview
9
Storing Scenes.
Store the scene using the [Tools] menu
See "IP Address Setup" on

Online

You can connect the DME or SP2060 unit to your computer and transfer configurations, scenes and
parameters created in DME Designer into the DME or SP2060 unit. You can also read data from the
DME or SP2060 unit into DME Designer, synchronizing it with the status of the DME or SP2060 unit.
Because Synchronization presupposes that the DME or SP2060 unit can communicate with the
computer where DME Designer is installed, the necessary drivers (USB-MIDI or DME-N Network
Driver) must be installed, and appropriate settings must be made for each driver and for DME
Designer MIDI port.
NOTE
Because there are no scene settings when the DME unit is purchased, the configuration and scene information created in
DME Designer must first be transferred.
NOTE
A maximum of 32 device groups can be online.
1
DME Unit and Computer Connection.
Connect the DME unit and computer using a USB cable or an Ethernet cable.
See separate "DME64N/24N Owner's Manual" for details.
2
MIDI Driver Installation.
Install the USB-MIDI driver or DME-N Network driver in the computer.
See separate "DME Designer Installation Guide" for details.
3
MIDI Driver Setup.
Make the necessary settings for the MIDI driver installed in the computer. If the driver is set up
already, check the settings before going online.
See separate "DME Designer Installation Guide" for details.
4
MIDI Driver Port Setup.
The MIDI Setup dialog will be displayed if you press the MIDI Setup button on the MIDI Setup
toolbar that is displayed when you start DME Designer Set up the In/Out/Thru ports connected to
the DME.
40 DME Designer Owner's Manual
[Scene Manager] command in the Main Panel window.
page 145.