Yamaha DME64N Owner's Manual page 295

Status Bar
Component Name
Component Name
Displays the component name.
Component ID
Displays the component ID.
NOTE
When controlling the DME64N/24N by connecting an RS-232C compatible controller to the [REMOTE] terminal, a
component ID is required for distinguishing the same components in the DME64N/24N. The component ID is included in
the signal that controls the component parameters. For details about control methods, contact your nearest Yamaha
representative or the authorized distributor at the end of the DME64N/24N Owner's Manual.
Parameter ID
Displays the parameter ID for controls that are being operated.
Snap
Up to four component editor parameter sets can be recorded temporarily. You can switch between
parameter sets using buttons.
Parameter sets can be copied by dragging and dropping a button onto any other button. Copy can
also be carried out from the contextual menu that appears when a button is right-clicked.
See "Snap"on page 335
Library
Saves and recalls component editor parameter sets as files.
See "Library" on page
The operation of component editor knobs and sliders, etc., can be specified the [Component Editor]
tab of the "Preferences" window in the main panel window. Refer to "Preferences" on
Component ID
337.
Chapter 5 Components
Parameter ID
page 62
DME Designer Owner's Manual 295