Yamaha DME64N Owner's Manual page 258

Chapter 4 Designer
Wire Drawing
Wire drawing starts at the positions shown in the following table:
Drawing Start Location
Hotspot
Wire End Terminal
Node
Line Segment
Anywhere on the Sheet
NOTE
When creating diagrams the keyboard cursor keys can be used to move the mouse cursor, and the <Enter. Key can be used
to create nodes.
Connecting Hotspots with Hotspots
Method 1 Clicking
Click the hotspot where the connection originates to begin drawing, then click the destination
hotspot. The two hotspots will be connected by a wire.
NOTE
A termination cannot be connected to a terminal that will be shorted. Multiple connections cannot be made to a DME
object's Cascade port.
NOTE
When creating diagrams horizontally aligned hot spots can be automatically connected by pressing the <Shift> + < >
keys or <Shift> + < > keys.
Method 2 Dragging
Drag from the origin hotspot to the destination hotspot.
NOTE
A termination cannot be connected to a terminal that will be shorted. Multiple connections cannot be made to a DME
object's Cascade port.
258 DME Designer Owner's Manual
Start Method
Click
Right-click click [Continue Wire] on the menu
Right-click click [Start Wire] on the menu
Right-click click [Start Wire] on the menu
Right-click click [Start Wire] on the menu