Yamaha DME64N Owner's Manual page 385

1
EQ Curve
Section Parameter
2
Input Level
3
Phase
4
Equalizer Type
5
Q
6
Frequency
7
Gain
8
Bypass
9
Equalizer PEQ ON
)
Output Level
!
On
Filter Type
Various types of curves are available for changing the level. Click the [Type] button and select the
type from the menu.
• PEQ
This is a general parametric equalizer.
• L. SHELF (Low Shelving)
There is no sound attenuation at low frequencies. The sound is attenuated at a constant rate
from the cutoff frequency towards the higher frequencies. The attenuation rate per octave can
be set to [6 dB/Oct] or [12 dB/Oct].
• H.SHELF (High Shelving)
There is no sound attenuation at high frequencies. The sound is attenuated at a constant rate
from the cutoff frequency towards the lower frequencies. The attenuation rate per octave can
be set to [6 dB/Oct] or [12 dB/Oct].
• HPF
This is a high-pass filter (Q=0.7). Attenuates the low frequencies with a gentle curve (12 dB/
Oct).
• LPF
This is a low-pass filter (Q=0.7). Attenuates the high frequencies with a gentle curve (12 dB/
Oct).
Name
Setting Range
- to +10 dB
ON/OFF
PEQ
L.SHELF 6 dB/Oct
L.SHELF 12 dB/Oct
H.SHELF 6 dB/Oct
H.SHELF 12 dB/Oct
HPF
LPF
0.1 to 16.0
20 Hz to 20 kHz
-18 dB to +18 dB
ON/OFF
ON/OFF
- to ±0 dB
ON/OFF
Chapter 6 Component Guide
Function
Displays the equalizer effect.
You can change the parameter by dragging
the control point with the mouse.
Function
Sets the input signal level.
Reverses the phase of the input signal.
Select the filter type from the menu.
Sets the band width for each frequency
band.
Sets the frequency for each band.
Sets the level of the frequency that will be
changed.
Turns ON bypass for each band.
Turns the PEQ ON
Sets the output signal level.
Turns output ON.
DME Designer Owner's Manual 385