Yamaha DME64N Owner's Manual page 152

Chapter 3 Main Panel Window
MIDI CH
Sets the MIDI channel. This number is also used as the Parameter Change Device ID.
Program Change/Control Change/Parameter Change
Sets transmit (Tx), receive (Rx), OMNI, and Echo for program change/control change/parameter
change. When ON, clicking turns this OFF. When OFF, clicking turns this ON. When OMNI is [ON]
channel messages are received regardless of the receive channel setting. When ECHO is [ON] the
input data is "echoed" (re-transmitted) via the output port that corresponds to the input port via
which it was received.
Program change, control change, and parameter change details can be set up via the "MIDI"
window [Program Change], [Control Change], and [Parameter Change] tabs, respectively.
Program Change/Control Change/Parameter Change
Sets transmit (Tx), receive (Rx), OMNI, and Echo for program change/control change/parameter
change. When ON, clicking turns this OFF. When OFF, clicking turns this ON. When OMNI is [ON]
channel messages are received regardless of the receive channel setting. When ECHO is [ON] the
input data is "echoed" (re-transmitted) via the output port that corresponds to the input port via
which it was received.
Program change, control change, and parameter change details can be set up via the "MIDI"
window [Program Change], [Control Change], and [Parameter Change] tabs, respectively.
GPI Tab
Calibrates the input voltage detection range for a DME unit GPI terminal.
[ALL] Checkbox
Automatically checks all channel checkboxes.
152 DME Designer Owner's Manual
• [Tx]
Select the MIDI transmit channel from the list.
• [Rx]
Select the MIDI receive channel from the list.