Yamaha DME64N Owner's Manual page 14

Getting Started
MIDI Setup
• A MIDI Setup minimize function has been added.
V1.2 Precautions
• When using project files (*.daf) created by version 1.1.5 or earlier, synchronize from the DME
Designer to the DME unit for the first synchronization.
• Project files (*.daf) created using version 1.2 will not open properly on version 1.1.
Changes from V1.2 to V2.0
General
• Support added for DME8i-C/DME8o-C/DME4io-C, SP2060 units and MY16-CII.
• "Device Groups", or groups of the same type of device, have been added at the lowest Zone
level.
• It is now possible to have one master device per device group rather than one master device per
zone. This means that it is possible to have multiple master devices in a single zone.
• Group masters can now be assigned regardless of the IP address. This makes it possible to have
multiple device groups at a single network address.
• Configurations can be created and deleted for each device group.
Component
• A Feedback Suppressor component has been added.
• The Speaker Processor component PEQ "Q" parameter now goes to "63".
Main Panel Window
• Firmware and component data can now be updated simultaneously.
• A Recovery Update function that allows recovery from program corruption has been added.
(page
• A Component Link function that allows simultaneous linking of all component parameters has
been added.
• Scene Link function that allows simultaneous control of multiple devices in different device
groups has been added.
• A Protect function has been added to the scene manager.
• Card settings are no longer included in scene data.
• A Utility window has been added to allow editing of device utility settings.
• The Local Parameter Link display order has been changed.
• Parameter Link operation can now be turned on or off for each device group.
• Compilation and analysis is now possible even if no connections have been made.
• Navigator window hide/show can now be selected from the main window.
• The Event Logger can now display only the event data for a specified device.
• The GPI terminal names have been changed from [CH] to [PORT].
Designer Window
• A hand tool for window movement has been added. The hand tool can be selected via the hand/
arrow icon in the toolbar, or from the [Tools] menu. The hand tool can also be temporarily
selected by holding the spacebar on your keyboard.
14 DME Designer Owner's Manual
162)
(page 81)
(page
(page
130)
387)
(page 427)
(page 160)
(page 70)
(page 146)
(page 81)
(page
(page
81)
65)