DME Setup Manual
This manual describes the process of setting up a DME system, from making the initial DME unit settings (DME64N /
DME24N / DME8i-C / DME8o-C / DME4io-C / DME8i-ES /DME8o-ES / DME4io-ES) to synchronizing with the DME
Designer application installed on a computer.
• For more details regarding a speciﬁc DME unit, please refer to the manual supplied with the unit in question, and for more details regarding the DME Designer application, please refer to the DME Designer manual (pdf).
• Please note that, within this document, the term "DME" refers to the DME64N and DME24N, while the term "DME Satellite" refers to the DME8i-C, DME8o-C, DME4io-C, DME8i-ES, DME8o-ES, and DME4io-ES
This sections covers procedures for either connecting a single DME unit to a computer or connecting multiple DME units to
2. Basic Setup
a single DME unit
directly to a computer via USB cable
Setting up DME cards
(only when expansion cards will be used)
Configuring components and Writing configurations
Going Online and Checking sound output
4. In-depth Information on DME Units
This section covers connection to
remote controllers via Ethernet
Detailed DME-N Network Driver settings
1. Installing the Software
1-1. Install DME Designer and DME-N Network Driver
1-2. Install the USB-MIDI Driver
Connecting Computer and DME unit
a computer within the same subnet.
Setting up DME64N/24N
This section explains how to setup networks directly
from a DME64N/24N.
3. Advanced Setup
multiple DME units
to a computer via Ethernet cables
Changing the computer's IP address settings
Setting the DME-N Network Driver
Connecting with DME Designer
Troubleshooting & Tips Chart
This chart serves as a quick guide to the steps that should be taken to
ensure correct operation of DME units.
Related web site on DME
Units and peripherals
This section serves as a guide to online
information on Speaker Processor Components
library data, optional cards, and touch-panel