Yamaha DME64N Owner's Manual page 281

Show Signal Delay (Delay Display Value)
The signal delays according to the processing time in the audio processor. The [Show Signal Delay]
command from the [Tools] menu calculates a delay value and displays it for the component. Selecting
this command switches delay value display between ON and OFF. A checkmark appears when
display is turned ON.
When turned ON, the settings are compiled to obtain a delay value, which is displayed for
components and lines. The delay value obtained through compilation remains valid until the
configuration is edited. Sample units are used to display the delay value.
This corresponds to the [Show Signal Delay] button on the toolbar.
ON and OFF settings for [Show Signal Display] are saved for each configuration window. Switching
the setting between ON and OFF in another configuration window has no effect on the current window.
You can edit the configuration while [Show Signal Delay] is turned ON.
When you turn ON [Show Signal Delay], the delay value appears
above the object.
Delay values for components and I/O components are displayed at the lower center of the object.
Delay values for wires are displayed beside the input port of the connected object.
NOTE
Delay values for SPX components vary depending on the Bypass ON/OFF status, because SPX components add the effect
signal to the original signal. When [Show Signal Delay] is turned ON, the delay value for the Bypass ON status will be
displayed.
NOTE
Delay values for Wav File Player components are displayed for external inputs. Delay values for local Wave files cannot be
displayed.
Chapter 4 Designer
DME Designer Owner's Manual 281