Creating An Acl - 3Com WX4400 Reference Manual

Creating an ACL

1 Access the Create ACL wizard:
2 In the ACL Name box, type the name for the ACL (1 to 32 alphanumeric
The Create ACL wizard enables you to configure ACEs with the following
parameters:
Match criteria:
Source IP address
Destination IP address
Protocol
Source protocol port
Destination protocol port
Differentiated Services Code Point (DSCP) value or Type Of Service
(TOS) and IP precedence values
Action: deny or permit
Marking: Class of Service (CoS) value
These parameters are sufficient for most ACEs. To configure additional
parameters, use the wizard to configure the basic parameters, then select
the ACE and click Properties. (See "Configuring Advanced ACL
Settings" on page 235.)
The ACL table might contain an ACL named portalacl. This ACL is created
automatically if you enable Web Portal be changing the fallthru
authentication type on a service profile or wired authentication port to
Web Portal.
To configure an ACL
a Select the Configuration tool bar option.
b In the Organizer panel, click the plus sign next to the WX switch.
c Click the plus sign next to System.
d Select ACLs.
e In the Task List panel, select ACL.
characters, with no spaces or tabs). The name can include hyphens (-),
underscores (_), or periods (.). ACL names are case-sensitive and must
begin with a letter. Do not include any of the following terms in the
name: all, default-action, map, help, editbuffer.
Viewing and Configuring ACLs 231