Viewing And Changing Rf Detection Settings; Viewing Rf Detection Settings; Adding An Entry To The Permitted Vendor Oui List - 3Com WX4400 Reference Manual

Viewing and
Changing RF
Detection Settings
Viewing RF Detection
Settings
Adding an Entry to
the Permitted Vendor
OUI List
(For information about the radio parameters in the table, see step 10 on
page 286. For information about the radio parameters in the Radio
Properties wizard, see step 13 on page 291.)
3 If you edit settings in the table, click Save. If you configure settings in the
Radio Properties wizard, clicking OK to close the wizard also saves the
changes.
This section contains procedures for configuring RF detection on an
individual switch. For an overview of RF detection and for specific
information about the configuration options, see "Configuring Wireless
Parameters" on page 245.
The tasks available here allow you to configure entries for permit lists, the
ignore list, and the black list. However, you must enter the SSID,
Organizationally Unique Identifier (OUI), or MAC address you are adding
to a list. To add a value to a list by selecting it, use the RF Detection
window instead. (See "Detecting and Combatting Rogue Devices" on
page 469.)
To convert a rogue into a third-party AP, see "Converting a Rogue into a
Third Party AP" on page 482.
To view RF detection settings:
1 Select the Configuration tool bar option.
2 In the Organizer panel, click the plus sign next to the WX switch.
3 Click the plus sign next to Wireless.
4 Select RF Detection.
The RF detection settings appear in the Content panel.
To add an entry to the permitted vendor OUI list:
1 Access the RF detection settings:
a Select the Configuration tool bar option.
b In the Organizer panel, click the plus sign next to the WX switch.

Viewing and Changing RF Detection Settings

293