Uploading A Partially Configured Switch And Completing Its; Configuration With 3Wxm - 3Com WX4400 Reference Manual

Uploading a Partially
Configured Switch
and Completing its
Configuration with
3WXM
Even if you do not know the serial number of a WX switch, you still can
configure the switch in 3WXM. When the switch contacts 3WXM for a
configuration, 3WXM generates a warning message such as the
following:
No M at chi ng conf i gur at i on f ound f or s er i al num ber –
serial-number; I P=ip-addr
You can upload the switch into 3WXM, complete its configuration, then
deploy the complete configuration back to the switch.
1 Select the Verification option on the 3WXM tool bar.
2 Click on the warning message.
3 In the Resolutions section, click on Upload WX to display the Upload WX
wizard.
4 The IP address is already filled in.
5 Type the Enable password, if one is configured on the switch. If an Enable
password has not been configured yet, leave the Enable Password box
blank.
6 Click Finish.
3WXM uploads the configuration file from the switch into the network
plan. The switch appears in the Equipment section of the Organizer
panel.
7 Select the Configuration tab on the 3WXM tool bar.
8 Select the WX switch.
9 Create or modify parameter settings for the switch.
After completing all of the changes, click Save.
10 Select the Verification option on the 3WXM tool bar.
11 Review any error or warning messages for the switch.
12 Click on an error or warning message to display more information, and a
list of resolutions for the error or warning condition.
13 Click on a resolution to correct the error or warning condition.
14 Select the Devices option on the 3WXM tool bar.
15 Select the switch.
16 In the Task List panel, select Deploy.
Preconfiguring a Switch in 3WXM 355