3Com WX4400 Reference Manual page 174

174 C 6: C
HAPTER ONFIGURING
WX S P
YSTEM ARAMETERS
Use this option if you used the Add button instead of the Move button
to place the ports in the VLAN. For a port to be a member of more than
one VLAN, the port must be tagged. By default, ports are untagged.
When you enable tagging, the default tag value is the same as the VLAN
ID.
11 Click Next.
12 Enter the IP address to match the address of the default router for the
default interface of the VLAN.
13 Click Next.
14 To place the switch in a Mobility Domain, select the Mobility Domain
from the Mobility Domain drop-down list.
The Mobility Domain must already be created. (See "Defining a Mobility
Domain" on page 64.) If you still need to create the Mobility Domain,
finish creating the switch, then create the Mobility Domain.
Select the switch in the Organizer panel to display its basic settings in the
Content panel, and select the Mobility Domain from the Mobility Domain
drop-down list.
15 To place the switch in a wiring closet, select the closet from the Wiring
Closet drop-down list.
The wiring closet must already be created on a floor plan. If you still need
to create the wiring closet, finish creating the switch, then create the
wiring closet. The Create Wiring Closet wizard in RF Planning enables you
to create a wiring closet and add the switch to it. (See "Creating a Wiring
Closet" on page 117.)
If you do not select the switch when you configure the wiring closet,
select the switch in the Organizer panel to display its basic settings in the
Content panel, and select the wiring closet from the Wiring Closet
drop-down list.
16 Click Finish.