Enabling Replacement Of Remote Switches - 3Com WX4400 Reference Manual

4 The new switch requests a configuration from 3WXM, using the process
5 3WXM finds a switch configuration that matches the model and MSS
Enabling
Replacement of
Remote Switches
1 Open the network plan that contains the remote switches you want to
2 Select Services > Setup from the menu bar in the main 3WXM window.
3 Select Server Settings in the left column.
4 Select Auto-Config IP Subnet Matching.
5 Click Save at the bottom of the page.
If the switch is a WXR100, the person at the remote office also inserts a
paperclip or similar object into the Fn hole of the WXR100 to press the Fn
switch. Normally, the Fn LED (the right LED above port 1) remains solidly
lit for 3 seconds after power on. However, when the Fn switch is pressed,
the LED flashes for 3 seconds instead.
described in "Drop Ship (WXR100 Only)" on page 346 or "Staged WX"
on page 348. (The process depends on whether the switch is a WXR100
or is any model that has been prestaged.)
version and has a management interface in the same subnet as the new
switch.
3WXM also notices that the serial number of the new switch does not
match the serial number in the switch configuration in 3WXM. However,
because the Auto-Config IP Subnet Matching option is enabled, 3WXM
does not reject the configuration request.
This configuration task is performed by the network administrator using
3WXM.
To enable replacement of remote switches
allow to be replaced.
The 3WXM Services Setup web page appears in your browser.
Replacing a Switch and Reusing its Configuration 357