Configuring Ntp - 3Com WX4400 Reference Manual

4 Type the server address in the IP Address box.
5 Select whether the server is primary or secondary.
6 Click OK.
7 In the Default DNS Domain box, type the default domain suffix that is

Configuring NTP

1 Access the Create NTP Server wizard:
2 To change the interval at which an NTP server is polled, specify its value in
3 Access the Create NTP Server wizard:
4 Type the server address in the IP Address box.
b In the Organizer panel, click the plus sign next to the WX switch.
c Click the plus sign next to System.
d Select IP Services.
e In the Task List panel, select DNS Server.
You can designate only one DNS server as the primary DNS server. All
other DNS servers are secondary servers.
appended to a hostname if the hostname cannot be resolved as entered.
The suffix can be up to 64 characters long with no spaces or tabs.
You can configure a WX switch to use the Network Time Protocol (NTP)
to automatically set the system date and time. NTP polls network time
servers at regular intervals and synchronizes the system date and time
with the servers. By default, NTP is not enabled. You can specify up to
three NTP servers.
If NTP is configured on a system whose current time differs from the NTP
server time by more than 10 minutes, convergence of the WX time can
take many NTP update intervals. 3Com recommends that you set the time
manually to the NTP server time before enabling NTP to avoid a
significant delay in convergence.
seconds (16 to 1024) in the Update Interval box. The default is 64
seconds.
a Select the Configuration tool bar option.
b In the Organizer panel, click the plus sign next to the WX switch.
c Click the plus sign next to System.
d Select IP Services.
e In the Task List panel, select NTP Server.
Viewing and Configuring IP Services Settings 213