Accepting Network Changes; Undoing Local Or Network Changes; Deploying Switch Configuration Changes - 3Com WX4400 Reference Manual

366 C 10: M
HAPTER ANAGING
Accepting Network
Changes
Undoing Local or
Network Changes
Deploying Switch
Configuration
Changes
WX S I
YSTEM MAGES AND
To accept network changes:
1 Select the Devices tool bar option.
2 At the bottom of the Task List panel, select Change Management.
3 Select one or more WX switches.
To select multiple switches, press Shift (for contiguous switches) or
Control (for noncontiguous switches) while clicking.
4 In the Task List panel in the Network Changes group, click Accept.
The status is shown in the Network Status and Local Status columns.
To undo local or network changes:
1 Select the Devices tool bar option.
2 At the bottom of the Task List panel, select Change Management.
3 Select one or more WX switches.
To select multiple switches, press Shift (for contiguous switches) or
Control (for noncontiguous switches) while clicking.
4 In the Local Changes or Network Changes group in the Task List panel,
select Undo.
Selecting Undo in Local Changes reverses changes made in 3WXM.
Selecting Undo in Network Changes reverses changes that have
occurred in the network.
The status is shown in the Network Status and Local Status columns.
You can deploy changes immediately or schedule them to be deployed
later.
When you deploy changes to a WX, all of the changes are sent as a single
transaction. If any parameter is unsuccessfully changed, the entire
transaction is rolled back. If the transaction is successful, the
configuration changes are immediately and dynamically put into effect.
(A reboot is not required.)
The following procedures provide steps for deploying configuration
changes from the Devices tab. You also can immediately deploy changes
from the Configuration tab, by clicking Deploy.
C
ONFIGURATIONS