Programming Memory Channels; D Programming In Vfo Mode - Icom IC-7200 Advanced Instructions

Previous view
7
MEMORY OPERATION

■ Programming memory channels

You can program the Memory channels in either the
VFO mode or in the Memory mode.

D Programming in VFO mode

V/M
Push to select the VFO mode.
q
[DIAL] to set the desired frequency, and
Rotate
w
then push
MODE
[M-CH] to select the desired memory chan-
Rotate
e
nel.
• If the RIT control indicator lights orange, push
(p. 7-2)
• " " appears if the selected memory channel is a
blank channel (one without any stored data.)
Lower channels
Hold down MW
r
frequency and operating mode into the selected
memory channel.
• 3 beeps sound when memory writing is completed.
to set the operating mode.
RIT control indicator
goes out
Higher channels
for 1 second to write the displayed
[EXAMPLE]: Programming 7.088 MHz/LSB
[EXAMPLE]: Programming 7.088 MHz/LSB
VFO mode
[EXAMPLE]: Programming 7.088 MHz/LSB VFO mode
[EXAMPLE]: Programming 7.088 MHz/LSB
VFO mode
M-CH/RIT
.
SET
VFO mode
7.088 MHz/LSB are programmed into channel 12.
7.088 MHz/LSB are programmed into channel 12.
7.088 MHz/LSB are programmed into channel 12.
7.088 MHz/LSB are programmed into channel 12.
7-3
into channel 12.
into channel 12.
into channel 12.
into channel 12.
7.088 MHz/LSB
Rotate [M-CH]
MW
Hold down
[DIAL] [M-CH]