Table of Contents
Advertisement
MEMORY PROGRAMMING
I General
The transceiver has 100 memory channels (plus 3 pairs of scan
edges and 1 call channel) for storage of often-used frequencies.
D Memory channel contents
The following information can be programmed into the memory:
• Operating frequency
• Duplex direction (+ or –) with an offset frequency (pgs. 21, 22)
• Subaudible tone encoder or tone squelch ON/OFF (pgs. 21, 34)
• Subaudible tone and tone squelch frequencies (pgs. 22, 35)
• Skip information* (p. 31)
*Except for scan edge channels.
I Programming the memory/call
channels
q
Push [D•
CLR
w
Set the desired frequency.
e
Set other information such as tone, duplex, etc. as desired.
r
Push [A•
FUNC
emitted) to program the information into the displayed memory
channel and return to VFO
• Continue to hold [C•
after 3 beeps are emitted, to increment the
displayed memory channel number
] to select VFO mode, if necessary.
], then push [C•
] down for 1 sec.
MR
] for 1 sec. (until 3 beeps are
MR
.
6
24
Advertisement
Table of Contents
