Local Logging; Real-Time Display - Extreme Networks Summit1 Installation And User Manual

L L
OCAL
The switch maintains 1,000 messages in its internal log. You can display a snapshot of
the log at any time by using the command
show log {<priority>} {<subsystem>}
where the following is true:
•
priority
(more critical). Priorities include critical, warning, and informational. If not specified,
informational priority messages and higher are displayed.
•
subsystem
subsystem. Subsystems include Syst, STP Brdg, SNMP, Telnet, VLAN, and Port. If
not specified, all subsystems are displayed.
R -
EAL TIME
In addition to viewing a snapshot of the switch log, you can configure the switch to
maintain a running real-time display of log messages on the console. To turn on the log
display, enter the following command:
enable log display
To configure the log display, use the following command:
config log display {<priority>} {<subsystem>}
If
priority
subsystem
If you enable the log display on a terminal connected to the console port, your settings
will remain in effect even after your console session is ended (unless you explicitly
disable the log display).
When using a Telnet connection, if your Telnet session is disconnected (because of the
inactivity timer, or for other reasons), the log display is automatically halted. You must
restart the log display by using the
S S I
UMMIT WITCH NSTALLATION AND
OGGING
— Filters the log to display message with the selected priority or higher
— Filters the log to display messages associated with the selected switch
D
ISPLAY
is not specified, only messages of critical priority are displayed. If the
is not specified, all subsystems are displayed.
U G
SER UIDE
enable log display
S
WITCH
command.
L
OGGING
12-11