Configuring Load Sharing; Port Combinations For The Summit1; Port Combinations For The Summit2; Port Combinations For The Summit3 - Extreme Networks Summit1 Installation And User Manual

C P
ONFIGURING ORTS
C L
ONFIGURING OAD
To set up the Summit to load share among ports, you must create a load-sharing group
of ports. Load-sharing groups are defined according to the following rules:
• Ports on the switch are divided into groups of two or four.
• Ports in a load-sharing group must be contiguous.
• Follow the outlined boxes in Table 4-2 through Table 4-6 to determine the valid port
combinations.
• The first port in the load-sharing group is configured to be the "master" logical port.
This is the reference port used in configuration commands. It can be thought of as
the logical port representing the entire port group.
Table 4-2, Table 4-3, Table
port group combinations for the Summit1, Summit2, Summit3, Summit4 and
Summit4/FX, and Summit48, respectively.
Table 4-2: Port Combinations for the Summit1
Load-Sharing
Group
4-port groups
2-port groups
Table 4-3: Port Combinations for the Summit2
Load-Sharing
Group 1 2
4-port groups x x
2-port groups x x
Table 4-4: Port Combinations for the Summit3
Load-Sharing
Group 1 2 3 4 5 6 7 8 9
4-port groups x x x x x x x x x x x x x x x x x x x x x x x x
2-port groups x x x x x x x x x x x x x x x x x x x x x x x x
4-6
S
HARING
4-4, Table 4-5, and Table 4-6
1 2 3 4
x
x x x
3 4 5 6 7 8
x x x x x x
x x x x x x
1 1
0 1
show the possible load-sharing
5 6 7 8
x x x
x x x
9 10 11 12 13 14 15 16 17 18
x x x x x x
x x x x x x
1 1 1 1 1 1 1 1
2 3 4 5 6 7 8 9
S
UMMIT
x x
x x x x
2 2 2 2 2 2
0 1 2 3 4 5
S I U
WITCH NSTALLATION AND
G
SER UIDE