Using Extremeware Vista; Enabling And Disabling Web Access - Extreme Networks Summit1 Installation And User Manual

13

Using ExtremeWare Vista

ExtremeWare Vista is device-management software running in the Summit that allows
you to access the switch over a TCP/IP network, using a standard Web browser. Any
properly configured standard Web browser that supports frames (such as Netscape
Navigator 3.0 or higher, or Microsoft Internet Explorer 3.0 or higher) can be used to
manage the switch.
ExtremeWare Vista provides a subset of the command-line interface (CLI) commands
available for configuring and monitoring the Summit. If a particular command is not
available using ExtremeWare Vista, you must use the command-line interface to access
the desired functionality.
E D W A
NABLING AND ISABLING EB CCESS
By default, Web access is enabled on the Summit. To disable it, use the following
command:
disable web
To re-enable Web access, use the following command:
enable web
You will need to reboot the switch in order for these changes to take effect.
For more information on rebooting the switch, refer to Chapter 14.
S S I U G 13-1
UMMIT WITCH NSTALLATION AND SER UIDE