Extreme Networks Summit1 Installation And User Manual page 163

Table 10-4: OSPF Configuration Commands (continued)
Command
config ospf delete virtual-link <routerid>
<areaid>
config ospf area <areaid> normal
config ospf area <areaid> stub [summary |
nosummary] stub-default-cost <cost>
config ospf area add range <ipaddress>
<mask> [advertise | noadvertise]
config ospf area delete range <ipaddress>
<mask>
config ospf routerid [automatic | <routerid>]
config ospf [vlan <name> | area <areaid> |
virtual-link <routerid>] timer
<retransmission_interval>
<transmission_delay> <hello_interval>
<dead_interval>
S S I
UMMIT WITCH NSTALLATION AND
U G
SER UIDE
Description
Removes a virtual link.
Configures an OSFP area as a normal area.
The default setting is normal.
Configures an OSPF area as a stub area. The
default setting is normal.
Configures a range of IP addresses in an
OSPF area. If advertised, the range is exported
as a single summary link state advertisement
by the ABR.
Deletes a range of IP addresses in an OSPF
area.
Configures the OSPF router ID. If automatic is
specified, the switch uses the largest IP
interface address as the OSPF router ID. The
default setting is automatic.
Configures the timers for one interface or all
interfaces in the same OSPF area. The
following default, minimum, and maximum
values (in seconds) are used:
Retransmission interval
Default: 5
Minimum: 0
Maximum: 3600
Transmission delay
Default: 1
Minimum: 0
Maximum: 3600
Hello interval
Default: 10
Minimum: 1
Maximum: 65535
Dead interval
Default: 40
Minimum: 1
Maximum: 2147483647
C OSPF
ONFIGURING
10-15