Basic Ip Commands - Extreme Networks Summit1 Installation And User Manual

V
ERIFYING THE
To verify the DHCP/BOOTP relay configuration, use the following command:
show ipconfig
This command displays the configuration of the BOOTP relay service, and the
addresses that are currently configured.
Table 9-1
Table 9-1: Basic IP Commands
Command
enable bootp vlan [<name> | all]
enable bootprelay
enable ipforwarding {vlan <name> | all}
enable ipforwarding broadcast {vlan <name> | all}
enable multinetting
config bootprelay add <ipaddress>
config bootprelay delete [<ipaddress> | all]
config iparp add <ipaddress> <mac_address>
config iparp delete <ipaddress>
S S I
UMMIT WITCH NSTALLATION AND
DHCP/BOOTP R
describes the commands used to configure basic IP settings on the switch.
U G
SER UIDE
C
ELAY ONFIGURATION
Description
Enables the generation and processing of
BOOTP packets on a VLAN to obtain an
IP address for the VLAN from a BOOTP
server. The default setting is enabled for
all VLANs.
Enables the forwarding of BOOTP and
Dynamic Host Configuration Protocol
(DHCP) requests.
Enables IP routing for one or more VLANs.
If no argument is provided, enables routing
for all VLANs that have been configured
with an IP address. The default setting for
ipforwarding is disabled.
Enables forwarding IP broadcast traffic for
one or more VLANs. If no argument is
provided, enables broadcast forwarding
for all VLANs. To enable, ipforwarding
must be enabled on the VLAN. The default
setting is enabled.
Enables IP multinetting on the switch/
Adds the IP destination address to
forward BOOTP packets.
Removes one or all IP destination
addresses for forwarding BOOTP packets.
Adds a permanent entry to the ARP table.
Specify the IP address and MAC address
of the entry.
Deletes an entry from the ARP table.
Specify the IP address of the entry.
C DHCP/BOOTP R
ONFIGURING ELAY
9-11