Software Upgrade And Boot Options; Downloading A New Image - Extreme Networks Summit1 Installation And User Manual

14 Software Upgrade and Boot
Options
This chapter describes the procedure for upgrading the switch software image. This
chapter also discusses how to save and load a primary and secondary image and
configuration file on the switch.
D N I
OWNLOADING A EW MAGE
The image file contains the executable code that runs on the Summit. It comes
preinstalled on the switch from the factory. As new versions of the image are released,
you should upgrade the software running on your switch.
The image is upgraded by using a download procedure from either a TFTP server on
the network or from a PC connected to the serial port using the XMODEM protocol.
Downloading a new image involves the following steps:
• Load the new image onto a TFTP server on your network, if you will be using TFTP.
• Load the new image onto a PC, if you will be using XMODEM.
S S I U G 14-1
UMMIT WITCH NSTALLATION AND SER UIDE