Igmp Configuration Commands - Extreme Networks Summit1 Installation And User Manual

IP M R
ULTICAST OUTING
Table 11-1: IP Multicast Routing Configuration Commands (continued)
Command
config dvmrp timer <route_report_interval>
<route_replacement_time>
config ipmc cache timeout <seconds>
Table 11-2 describes the command used to configure the Internet Gateway Message
Protocol (IGMP).
Table 11-2: IGMP Configuration Commands
Command
enable igmp {vlan <name> | all}
enable igmp snooping {vlan <name> | all}
11-4
Description
Configures the global DVMRP timers. Specify
the following:
route_report_interval — The amount
of time the switch waits between transmitting
periodic route report packets. The range is 1
to 4294967296 seconds (136 years). The
default setting is 60 seconds.
route_replacement_time — The
hold-down time before a new route is
learned, once the previous route has been
deleted. The range is 1 to 4294967296
seconds (136 years). The default setting is
140 seconds.
Configures the aging time for IP multicast cache
entries. The default setting is 300 seconds.
Description
Enables IGMP on a router interface. The default
setting is enabled.
Enables IGMP snooping. The default setting is
disabled.
S S I
UMMIT WITCH NSTALLATION AND
U G
SER UIDE