Ip Host Configuration Commands - Extreme Networks Summit1 Installation And User Manual

A T S
CCESSING HE WITCH
IP H C
OST ONFIGURATION
Table 3-5 describes the commands that are used to configure IP settings on the switch.
Table 3-5: IP Host Configuration Commands
Command
config iparp add <ipaddress> <mac_address>
config iparp delete <ipaddress>
clear iparp [<ipaddress> | vlan <name> | all]
config iproute add <ipaddress> <mask> <gateway>
{<metric>}
config iproute delete <ipaddress> <mask>
<gateway>
config iproute add default <gateway> {<metric>}
config iproute delete default <gateway>
show ipconfig {vlan <name> | all}
show ipstats {vlan [<name> | all]}
show iparp {<ipaddress | vlan <name> | all |
permanent}
3-16
C
OMMANDS
Description
Adds a permanent entry to the ARP table.
Specify the IP address and MAC address
of the entry.
Deletes an entry from the ARP table.
Specify the IP address of the entry.
Removes dynamic entries in the IP ARP
table. Permanent IP ARP entries are not
affected.
Adds a static address to the routing table.
Use a value of 255.255.255.255 for mask
to indicate a host entry
Deletes a static address from the routing
table.
Adds a default gateway to the routing
table. A default gateway must be located
on a configured IP interface. If no metric is
specified, the default metric of 1 is used.
Deletes a default gateway from the
routing table.
Displays configuration information for one
or more VLANs.
Displays IP statistics for the CPU of the
switch.
Displays the IP ARP table. You can filter
the display by IP address, VLAN, or
permanent entries.
S S I
UMMIT WITCH NSTALLATION AND
U G
SER UIDE