Summit Virtual Chassis Commands; Configuring The Chassis - Extreme Networks Summit1 Installation And User Manual

C P
ONFIGURING ORTS
S V
UMMIT IRTUAL
Table 4-9 lists commands that are used on the Summit switch to connect it to a Summit
Virtual Chassis.
Table 4-9: Summit Virtual Chassis Commands
Command
show edp
enable summitlink port <portlist>
disable summitlink port <portlist>
enable edp port <portlist>
disable edp port <portlist>
C
ONFIGURING THE
C
HASSIS
You must configure the Summit switch port(s) prior to connecting the switch to the
Summit Virtual Chassis. Each connected port must be configured as a SummitLink port,
using the following command:
enable summitlink port <portlist>
If you are using a parallel Virtual Chassis stack, you must configure load-sharing on the
Summit after the ports are designated as SummitLink ports. This is done using the
following command:
enable sharing <master port> grouping <portlist>
4-12
C C
HASSIS OMMANDS
Description
Displays connectivity information for neighboring
Summit switches.
Enables the port to connect to a SummitLink port
on the Summit Virtual Chassis. SummitLink cannot
be enabled if multiple STPDs are configured on
the port. The default setting is disabled.
Disables the connection to the SummitLink port on
the Summit Virtual Chassis.
Enables the generation and processing of Extreme
Discovery Protocol message on one or more ports.
The default setting is enabled.
Disables the Extreme Discovery Protocol on one or
more ports. EDP cannot be disabled on a port that
has SummitLInk enabled.
S U
UMMIT FOR SER WITH THE
S V
UMMIT IRTUAL
S S I
UMMIT WITCH NSTALLATION AND
U G
SER UIDE