Configuring Qos; Qos Configuration Commands - Extreme Networks Summit1 Installation And User Manual

Q S (Q S)
UALITY OF ERVICE O
C
ONFIGURING
Table 8-4 describes the commands used to configure QoS.
Table 8-4: QoS Configuration Commands
Command
enable pace
create qosprofile <qosname>
config qosmode [ingress | egress]
config qosprofile <qosname> {minbw <percent>}
{maxbw <percent>} {priority <level>}
config port <portlist> qosprofile <qosname>
config vlan <name> qosprofile <qosname>
disable pace
8-8
Q S
O
Description
Enables recognition of the PACE bit.
Available in ingress mode, only.
Creates a QoS profile. The default values
assigned to a created QoS profile are:
Minimum bandwidth — 0%
Maximum bandwidth — 100%
Priority — low
Changes the QoS mode to ingress mode
or egress mode.
Configures a QoS profile. Specify:
minbw — The minimum bandwidth
percentage guaranteed to be available
to this queue. The default setting is 0.
maxbw — The maximum bandwidth
percentage this queue is permitted to
use. The default setting is 100.
priority — The service priority for
this queue. Settings include low,
medium-low, medium, high. The default
setting is low. Available in egress mode,
only.
Allows you to configure one or more ports
to use a particular QoS profile. Available
in ingress mode, only.
Allows you to configure a VLAN to use a
particular QoS profile.
Disables recognition of the PACE bit.
Available in ingress mode, only.
S
UMMIT
S I U
WITCH NSTALLATION AND SER
G
UIDE