Disconnecting A Telnet Session; Disabling Telnet Access - Extreme Networks Summit1 Installation And User Manual

8 When you are finished using the facility, log out of the switch by typing
logout
D
ISCONNECTING A
The administrator-level account can disconnect a management session that has been
established by way of a Telnet connection. If this happens, the user logged in by way of
the Telnet connection is notified that the session has been terminated.
To terminate a Telnet session, follow these steps:
1 Log in to the switch with administrator privileges.
2 Determine the session number of the session you want to terminate by typing
show session
Sample output from the
show session:
0 Wed Sep 17 20:48:38 1997
4 Wed Sep 17 21:52:16 1997
3 Terminate the session by using the following command:
clear session <session_number>
D
ISABLING
By default, Telnet services are enabled on the switch. You can choose to disable Telnet
by entering
disable telnet
To re-enable Telnet on the switch, at the console port enter
enable telnet
You must be logged in as an administrator to enable or disable Telnet.
S S I
UMMIT WITCH NSTALLATION AND
T
ELNET
show session
T A
ELNET CCESS
U G
SER UIDE
S
ESSION
command is as follows:
admin console serial
admin telnet 192.208.37.26
U T
SING ELNET
3-15