Port Commands - Extreme Networks Summit1 Installation And User Manual

P
ORT
Table 4-1
Table 4-1: Port Commands
Command
enable learning port <portlist>
enable port <portlist>
enable sharing <master_port> grouping
<portlist>
enable smartredundancy <portlist>
config port <portlist> auto on
config port <portlist> auto off {speed [10 |
100]} duplex [half | full]
config port <portlist> qosprofile <qosname>
disable learning port <portlist>
disable port <portlist>
disable sharing <master_port>
S S I
UMMIT WITCH NSTALLATION AND
C
OMMANDS
describes the port commands.
U G
SER UIDE
Description
Enables MAC address learning on one or more
ports. The default setting is enabled.
Enables a port.
Defines a load-sharing group of ports. The ports
specified in <portlist> are grouped to the
master port.
Enables the smart redundancy feature on the
redundant Gigabit Ethernet port. When the smart
redundancy feature is enabled, the switch
always uses the primary link when the primary
link is available. The default setting is enabled.
Enables autonegotiation for the particular port
type; 802.3u for 10/100 Mbps ports or 802.3z for
Gigabit Ethernet ports.
Changes the configuration of a group of ports.
Specify the following:
auto off — the port will not autonegotiate
the settings
speed — the speed of the port (for 10/100
Mbps ports only)
duplex — the duplex setting (half- or
full-duplex)
Configures one or more ports to use a particular
QoS profile.
Disables MAC address learning on one or more
ports for security purposes. If MAC address
learning is disabled, only broadcast traffic and
packets destined to a permanent MAC address
matching that port number, are forwarded. The
default setting is enabled.
Disables a port. Even when disabled, the link is
available for diagnostic purposes.
Disables a load-sharing group of ports.
P C
ORT OMMANDS
4-3