Extreme Networks Summit1 Installation And User Manual page 203

S
AVING
The configuration is the customized set of parameters that you have selected to run on
the switch. As you make configuration changes, the new settings are stored in run-time
memory. Settings that are stored in run-time memory are not retained by the switch
when the switch is rebooted. To retain the settings, and have them be loaded when you
reboot the switch, you must save the configuration to nonvolatile RAM (NVRAM).
The Summit can store two different configurations: a primary and a secondary. When
you save configuration changes, you can select to which configuration you want the
changes saved. If you do not specify, the changes are saved to the configuration area
currently in use.
If you have made a mistake, or you must revert to the configuration as it was before
you started making changes, you can tell the switch to use the secondary configuration
on the next reboot.
To save the configuration, use the following command:
save {config} {primary | secondary}
To use the configuration, use the following command:
use config {primary | secondary | imported}
The configuration takes effect on the next reboot.
If the switch is rebooted while in the middle of a configuration save, the switch
boots to factory default settings. The configuration that is not in the process of
being saved is unaffected.
R
ETURNING TO
To return the switch configuration to factory defaults, use the following command:
unconfig switch
This command resets the entire configuration, with the exception of user accounts and
passwords that have been configured.
To reset all parameters, use the following command:
unconfig switch all
S S I
UMMIT WITCH NSTALLATION AND
C
ONFIGURATION
F D
ACTORY
U G
SER UIDE
C
HANGES
EFAULTS
S C C
AVING ONFIGURATION HANGES
14-3