Setting The Direct Monitor - Boss GT-10 Owner's Manual

Setting the Direct Monitor

Switches the output of the GT-10 sound to the OUTPUT and PHONES jacks.
SYSTEM
The SYSTEM MENU screen appears.
1.
Select USB.
2.
The USB screen appears.
3.
Move the cursor to Dir.Monitor.
4.
Select the Monitor mode.
5.
Parameter/ Explanation
Range
Set this to Off if transmitting audio data internally
through a computer (Thru).
Off
No sound is heard at this time unless the setting for
the computer is Thru.
The GT-10 sound is output. Set this to On when using
the GT-10 as a standalone device, without connecting
On
to a computer (only USB In input sound will be out-
put if this is set to Off).
• This setting cannot be saved. It is set to On when the power is turned on.
• If you are using the special driver, you can control Dir.Monitor On/Off
from ASIO 2.0-compatible application.
Chapter 7 Using the GT-10 Connected to a Computer Via USB
For more information on signal paths set by the
Direct Monitor parameter settings, refer to "Signal
Flow" (p. 142).
Audio signal
USB OUT USB IN
Dir.Monitor
GT-10 sound
Computer
Audio IN
Audio OUT
Guitar Amp
OUTPUT L/R
Headphones
PHONES
93