Table of Contents
Advertisement
Various Settings
Setting the Expression Pedal Function
By connecting an expression pedal (such as the EV-30, sold separately) to the CTL 1, 2/EXP jack, you can operate the top panel
knobs except for the Mode knob.
You can set the respective sounds for when the expression pedal is at MAX position (pushed all the way up with your toes) and at
MIN position (pushed all the way down with your heel), and make continuous changes to them.
You can use different expression pedal settings for MANUAL and for each memory in MEMORY 1–4 respectively.
You can also set and add a different function to the functions you've already set. This lets you create settings that operate multiple
knobs at once.
1.
Use the [MEMORY] button to select the memory (MANUAL, MEMORY 1–4) for which you want to
configure the expression pedal.
2.
Hold down the [TAP] switch and press the [TAP DIVISION] button.
The TRI indicator blinks
3.
Use the respective knobs to set the sound that's used when the pedal is at the MIN value (pushed all the
way down with your heel).
4.
Press the [TAP DIVISION] button again.
The DOT indicator blinks.
5.
Use the respective knobs to set the sound that's used when the pedal is at the MAX value (pushed all the
way up with your toes).
6.
Press the [TAP DIVISION] button again to exit the function settings.
If you want to clear the function settings for the expression pedal, go through steps 1 to 6 above without operating any knobs
in steps 3 and 6.
●
To save the expression pedal function settings, you must save the memory.
●
Use only the specified expression pedal. Connecting expression pedals made by third-party manufacturers may
cause this unit to malfunction.
Various Settings
11
Advertisement
Table of Contents
