Boss GT-10 Owner's Manual page 52

Chapter 4 Playing Sounds
Parameters That Can Be Set in List View
The following describes the parameters that can be set when you switch to List View in the ASSIGN screen.
The screen that's shown uses ASSIGN No. 1 as an example.
Parameter Explanation
Target Use to select the parameter you want to control.
Min This sets the minimum value for the target's controllable range.
Max This sets the maximum value for the target's controllable range.
Parameter Explanation
Source This selects the controller assigned to the function.
Moment
Src Mode
Toggle
ActRngLo This sets the minimum for the range in which the value of the setting can be changed.
ActRngHi This sets the maximum for the range in which the value of the setting can be changed.
For more information about each parameter, refer to "ASSIGN 1–8" (p. 126).
52
The normal state is Off (minimum value), with the switch On (maximum
value) only while the footswitch is depressed.
The setting is toggled On (maximum value) or Off (minimum value) with
each press of the footswitch.